Laptop Computer Repair - computer clean Fans

All laptop repairs are not equal. able to repair the computer itself can vary greatly from model to model.

This article guides you through the steps on how to repair a computer to keep running to catch cold. On some models of laptop, is quite easy to remove and clean the CPU fan, but on others you need a qualified technician to do the job. Clean the fan computer, such as an Acer Extensa is very simple. To begin, you need the followingFacilities:

Before Small screwdriver
Second air blower
Third tube thermal compound

First, start using the five screws on the bottom of the laptop. Leveraging the cover. Felt a slight popping noise when removing, but do not worry, it should come without problems. Therefore, you must remove the five screws holding the heatsink and then the two screws securing the CPU fan. Attention is a plug connected to the fan, you must ensureMake sure you pull the plastic connector to remove it does not pull the cord.

Second, you remove the accumulated heat sink and spray from the computer with compressed air to blow dust and dirt. Then do you remove the fan and the same, but make sure you keep the fan in place if you breath the air. If you do not want to turn the fan because the leaves are tender and could be damaged.

Finally, the last step to inspect the repair on this computerto see the heat sink, if the thermal paste that is sitting on a small copper plate, hardened and cracked. If the dough is still the consistency of toothpaste, does not need to be replaced. However, if it hardens, take a credit card or other pieces of thin plastic gently scrape the hard material, both the heat sink can be used and removed the plate inside the computer. Do not use knives or other metal objects, you warrant no scratches on the copper surface.If you are ready to apply the new dough, first clean the surface with a paper towel and then blow again with compressed air. Place a small piece of dough on the sink and spread evenly and place the back of the computer.

Now you are ready to put the fan with two screws and do not forget to install the plug again. Do not torque the screws, do not want to deform under the motherboard with the screws too tight. Even if you replace theback cover, working around the star, while the five screws, this will help ensure a good for everyone, even the way around the lid.

Please read our two videos, repairs will be a step by step through this: Cleaning up a portable fan video and laptop cleaning fan video two.

My Links : Sony VAIO VPC-EB11FX/WI